Home > News > Introduction to optical design > Daily maintenance instructions.....


Daily maintenance instructions for laser marking machine accessories

Laser marking machine continues to increase with the use of time, some of the parts are wearable parts, such parts generally need to be replaced regularly, otherwise the entire machine will not work properly. For example: reflective lens, the lens will cause certain damage as the use time increases, so this lens must be replaced regularly, otherwise it will affect the use of the marking machine.

Green laser marking machine in china are expensive and frequently used. Daily attention should be paid to the maintenance and maintenance of laser machine accessories to increase the service life of the equipment, save costs, and create greater benefits.So which parts of the need frequent maintenance?

1. If the galvanometer of the laser marking machine does not move, or does not move in one direction, you need to check whether the galvanometer XY status indicator is normal, check whether the galvanometer wiring is loose, check whether the power supply of the galvanometer switch power supply is normal, and check the vibration of the USB board. Whether the output signal of the mirror is normal.

2. Fan cleaning: Long-term use of the fan will accumulate a lot of solid dust in the fan, make the fan a lot of noise, and it is not conducive to exhaust and deodorization.

3. The field lens of the laser marking machine needs to be cleaned regularly, because it is outside and there will be dust when marking. If the lens is not cleaned for a long time, there will be a layer of dust on the lens, and it will affect the light quality of the laser marking machine. It may burn the lens.

4. Different brands of laser chillers are different. If the laser chiller alarms, the laser marking machine cannot be used, because the laser power supply cannot be started in the alarm situation. The laser chiller alarms are mainly flow alarms and compressors. High pressure alarm, if there is an alarm, we should first check whether the chiller of the laser marking machine has water pressure, mainly to check whether the water pressure of the chiller is normal, if there is no flow, then the water pump of the chiller may be broken or the pressure is not enough, and vice versa That is, the flow switch of the chiller is damaged. We will repair and deal with the failure according to the actual situation.
It can be solved by replacing some small accessories, such as temperature detector, flow switch, adding refrigerant, cleaning dust, replacing water pump, replacing chiller control panel, etc. If the above maintenance cost exceeds half the price of a new chiller, China Laser Marking machine factory it is recommended to replace a more secure chiller.

5. Check whether there are any signs of looseness in the waterway joints every time you turn on the machine, and whether there is water leakage. If there is water leakage, quickly press the emergency stop switch to repair it.

When using the laser marking machine, not only must strictly follow the instructions for use, but also the above points need frequent maintenance before and after use, so as to ensure the normal use of the laser marking machine and prolong its service life.