Home > News > Introduction to optical design > How to install the laser cutting machine lens correctly
Certifications
Contact Us
Suzhou Carman Haas Laser Technology Co., Ltd
Address: No 155, West Road Suhong, Suzhou Industrial Park, Suzhou City, Jiangsu , P.R. China
Tel: +86-18211675110  
Fax: +86-512-67678768  
E-mail:wangxin@carmanhaas.com
https://www.carmanhaaslaser.com Contact Now

News

How to install the laser cutting machine lens correctly

2020-07-22 16:10:01

The laser lens occupies a very important position in the laser system. The change of the laser light path is realized by the refraction of the lens, and the function of the laser lens is designed to protect the focusing lens. Protect the lens during the installation and cleaning process, any sticky matter, or even oil droplets printed on the nails, will increase the absorption rate of the lens and reduce the service life.




Laser cutting is a high-precision mechanical equipment, which requires stricter requirements during use. Among them, a very critical part of the laser cutting effect is the installation of the laser cutting machine lens. If the installation is not performed in accordance with the prescribed steps, it will easily lead to the cutting center. Deviation or even misalignment of cutting machine groove edge. So what aspects should be paid attention to when installing the laser cutting machine lens?

Step 1: Please wash your hands before operation. It is best to wash your hands with soap or detergent. This is a good habit for normal operation of the cutting machine lens. Do not directly touch the lens with your bare hands. Wear special gloves to prevent fingerprints from being left on the lens to affect accuracy.

Step 2: When placing the lens, you should pay attention to it stably to prevent it from falling and being damaged. At the same time, pay attention to the convex surface of the lens and place it flat on a stable and clean table. At the same time, check that there is no debris on the desktop to avoid confusion or affect the operating environment of the lens.

Step 3: Protect the lens of the laser cutting machine from moisture. You can't use the traditional blowing method to wipe the lens, and you can't use hot air to blow on the lens to avoid the sudden change of heat and damage the lens. The lens is of high precision, temperature and humidity are strictly controlled, so as not to affect the lens surface protective film and optical accuracy.






Step 4: After the laser cutting machine lens is assembled, pay attention to the cleaning and dust removal of the lens. It is best to use a clean air spray gun to clean it, not an ordinary spray gun.

Step 5: The lens of the cutter must be kept absolutely clean, and do not touch the surface of the lens directly with your hands, and strictly prevent other non-designated items from directly contacting the surface of the lens. In the cleaning and maintenance of the lens, use a professional wipe paper to gently pull it from side to side to avoid scratching the surface of the lens.